Course Introduction
Windows (PC, laptop)
Mac (Apple only)
Lesson #1: Getting Started - Blinking LED
Lesson #2: Button with LED
Lesson #3: Potentiometer with LEDs
Lesson #4: Potentiometer with Servo
Lesson #5: 16x2 LCD display
Lesson #6: Password lock - 16x2 LCD Display with keypad
Lesson #7: DHT11 Temperature Sensor
Lesson #8: Binary Counting
Lesson #9: Scrolling LED
Lesson #10: Parking with 7-segment display
Lesson #11: Christmas Tree with LEDs
Lesson #12: RGB-LED with Potentiometers
Lesson #13: StepperMotor Control
Lesson #14: Steppermotor SpeedControl
Lesson #15: Motor Wheels
Lesson #16: Motion detection with 16x2 LCD Display
Lesson #17: Tone keyboard
Lesson #18: LED Dice
Lesson #19: Traffic light
Lesson #20: Keypad with 4 LEDs

Connect the Arduino/HERO board

The first step is the most simple one. Connect your HERO Board with the computer and the circuit is built.

The simulator always needs a board to communicate with.

Thanks to the simulation software, the building of circuits has been omitted and this makes it much easier to test your code. The simulator can also simulate missing parts while parts are still built up. Suppose you miss a button, connect your other components and simulate the button on the screen.

Make sure to install the Arduino IDE where you will write the codes in.