Course Introduction
Windows (PC, laptop)
Mac (Apple only)
Lesson #1: Getting Started - Blinking LED
Lesson #2: Button with LED
Lesson #3: Potentiometer with LEDs
Lesson #4: Potentiometer with Servo
Lesson #5: 16x2 LCD display
Lesson #6: Password lock - 16x2 LCD Display with keypad
Lesson #7: DHT11 Temperature Sensor
Lesson #8: Binary Counting
Lesson #9: Scrolling LED
Lesson #10: Parking with 7-segment display
Lesson #11: Christmas Tree with LEDs
Lesson #12: RGB-LED with Potentiometers
Lesson #13: StepperMotor Control
Lesson #14: Steppermotor SpeedControl
Lesson #15: Motor Wheels
Lesson #16: Motion detection with 16x2 LCD Display
Lesson #17: Tone keyboard
Lesson #18: LED Dice
Lesson #19: Traffic light
Lesson #20: Keypad with 4 LEDs

Simulation – Steppermotor speedcontrol

In this project we will control a stepper motor with 4 coil windings. More information about the stepper motor can be found here. This example can be found by the examples provided in the simulator. The steps are shown in the video above.

Select IO

Drag the stepper motor in the work space and connect the Arduino board first. Select the 4 coil windings. If you enter a value for the number of steps, press enter to send the data to the Arduino. Select the analog pin A0 for the speed slider. The stepper motor speed will be controlled by the potentiometer (slider). Sometimes the slider value is not received by the Arduino because the serial line is quite busy sending the stepper motor values back and forth.

You can restore saved setups by going under File and choose for ‘Restore settings’. Select the setup file and all the saved settings will be restored.

Arduino code